Rechargeable Wireless LED Motion Sensor Night Light, Stick-on Anywhere Under Cabinet LED Light w/ Magnet, USB Cable, Base Plate, 3M Adhesive for Kitchen/Drawer/Closet/Corridor/Stairs/Trunk Lighting

Description

Ultra compact & lightweight motion sensor LED under cabinet light adopt with high bright Epistar LED light source, combining passive
infrared (PIR) technology to detect motions.

Under AUTO mode, it will turns on in the dark when you get within 3 meters to it. It will turn itself off after 15 seconds of walking out
of its path.

With a rechargeable lithium battery, it will lasts up to 4 hours without charging, if it were on constantly. It will last 2 months while on
auto mode. When it runs out, you just plug it in with the USB charging cable it comes with for less than an hour and it s ready to go again.

For installation, back magnetic field is easily attached to a metallic surface; hanging slot and 3M dual-adhesive tape make
it stick-on anywhere.

On/Off/Auto modes:
ON: constant lighting, can be used as a flashlight or emergency lighting
OFF: turn light off
AUTO: auto-sensing state, light up automatically in the dark when motion is detected.

Suitable for the usage in auto trunk, bedroom, closet, cabinet, mirror, corridor, workshop, basement, garage, stairwell, oil depots, roof,
door, garage entrances and oth

3 position switch

ON: constant lighting
OFF: turn light off
AUTO: auto-sensing state, light up automatically in the dark when motion is detected.

Specification

Detection range: 10ft
Detection angle: up to approx 30° (vertical)
up to approx 60°(horizontal)
Current: 180mA
Input voltage: 5V DC
Output voltage: 3.7V
Brightness: 100lm

Notices

-Non-waterproof, do not use it in any heavy humidity or low temp location.
-Try not to mount 2 lights so near. They may interact each other in AUTO mode.

Package：

1×motion sensor light
1×USB charging cable
1×base plate
1×3M adhesive tape